Crosley GAS RANGE Use and Care Guide download pdf (Page 4)

C. Level and Position Range - Level range by adjusting the

(4) leveling legs with a wrench. Note: A minimum clearance

of 1/8" is required between the bottom of the range and the

leveling leg to allow room for the bracket. Use a spirit level

to check your adjustments. Slide range back into position.

Visually check that rear leveling leg is inserted into and

fully secured by the Anti-Tip Bracket by removing lower

panel or storage drawer. For models with a warmer drawer

or broiler compartment, grasp the top rear edge of the

range and carefully attempt to tilt it forward.

2. Provide an adequate gas supply.

This unit is pre-set to operate on 4" natural gas manifold

pressure. A convertible pressure regulator is connected to

the manifold and MUST be connected in series with the gas

supply line. If the LP/Propane conversion kit has been used,

follow instructions provided with the kit for converting the

pressure regulator to LP/Propane use. The LP kit can be found

on the back side of the range.

Care must be taken during installation of range not to obstruct

the flow of combustion and ventilation air.

For proper operation, the maximum inlet pressure to the

regulator should be no more than 14 inches of water column

pressure. The inlet pressure to the regulator must be at least

1 inch greater than regulator manifold pressure. Examples: If

regulator is set for natural gas 4 inch manifold pressure, inlet

pressure must be at least 5 inches; if regulator has been

converted for LP/Propane gas 10 inch manifold pressure,

inlet pressure must be at least 11 inches.

Leak testing of the appliance shall be conducted according to

the instructions in step 4g.

The gas supply line should be 1/2" or 3/4" I.D.

3. Seal the openings.

Seal any openings in the wall behind the range and in the floor

under the range after gas supply line is installed.

4. Connect the range to the gas supply.

To prevent leaks, put a pipe joint sealant on all male (outside)

pipe threads.

Your regulator is in the location shown below.

Do not allow regulator to turn on pipe when

tightening fittings.

30" GAS RANGE INSTALLATION INSTRUCTIONS

(For Models with Sealed Top Burners)

1 2 3 4 5 6 7 8

No comments

Crosley GAS RANGE Use and Care Guide Page 4