Crosley GAS RANGE Use and Care Guide Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
6
30" GAS RANGE INSTALLATION INSTRUCTIONS
(For Models with Sealed Top Burners)
6. Assembly of the Surface Burner Heads, Burner
Caps and Burner Grates:
It is very important to makes sure that all of the Surface Burner
Heads, Surface Burner Caps and Surface Burner Grates are
installed correctly and in the correct locations (See Fig. 1).
Fig. 3
1. Match the letter located under center of Burner Cap with
letters located inside the Burner Heads (See Fig. 1).
2. Match the letter stamped on the Burner Skirt with the
Burner Head and Burner Cap. Each of the Burner Heads
MUST have a Burner Cap installed to insure proper
ignition and gas flame size. Note: The Burner Electrodes
must be located properly in slot of each Burner Head (See
Fig. 2).
7. Electric Ignition Surface Burners
Operation of electric igniters should be checked after range and
supply line connectors have been carefully checked for leaks
and range has been connected to electric power.
a. To check for proper lighting, push in and turn a surface
burner knob counterclockwise to the LITE position. You
will hear the igniter sparking (See Fig. 3).
b. The surface burner should light when gas is available to
the top burner. Purge air from supply lines by leaving knob
in the LITE position until burner ignites. Each burner
should light within four (4) seconds in normal operation
after air has been purged from supply lines.
c. Visually check that burner has lit. Once the burner lights,
the control knob should be turned out of the LITE position.
d. There are separate electrodes (igniters) for each burner.
Try each knob separately until all burner valves have been
checked.
Fig. 1
REMEMBER — DO NOT ALLOW SPILLS, FOOD,
CLEANING AGENTS OR ANY OTHER MATERIAL TO
ENTER THE GAS ORIFICE HOLDER OPENING. Always
keep the Burner Caps and Burner Heads in place whenever
the surface burners are in use.
Burner Assembly
Burner sizes and locations
Front of cooktop
Fig. 2
Page view 5
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments